We accept the following payments

 Acceptance Mark


 


 

Home     Decoupage Papers     What's New      Supplies & Kits      How-To-Projects      Gallery     Jewelry  Contact Us  
decoupage paper collage sheet glass plate decoupage paper collage sheet wood plaque decoupage paper collage sheet floor cloth

decoupage paper collage sheet purse 

decoupage paper collage sheet jewelry box

decoupage paper collage sheet clay pot decouapge paper collage sheet how to wood bracelet

Wood Jewelry Box
Original Tissue Decoupage Papers, Flexible & Sturdy with a Hand-Painted Look!!!
Each sheet is 8-1/2" x 11" with multiple laser printed images
 

 

Supplies Needed:
Most of these supplies can be purchased at you local craft and stamp stores  

            Wooden Box and Feet
            Fine sand paper 
            Stencils in simple shapes  
            All Purpose Acrylic Sealer
            Sponge Brush

            Elmer's Glue-all
            Water based semi-gloss varnish
            Stipple Brush
            Tissue Decoupage Papers Floral DL116
            Tissue Decoupage Papers Accessories DA110

1) Start by preparing your surface. Remove hardware from box.  Lightly sand box and feet with fine sand paper.  Seal with a all-purpose acrylic sealer, let dry.  Lightly sand again. 

2) Paint with white acrylic paint, let dry.

3) Cut out your decoupage paper designs. Use a small pair of embroidery scissors.  Pre-arrange your designs on your surface. (Once you decoupage your design it cannot be removed.)

4) Remove white paper backing from cutout. Slightly water down your Elmer's glue-all.  Apply thin coat of glue to the back of your cutout, let set for 5 seconds until the paper uncurls.

5) Apply paper to your surface. With your fingers gently press from center toward ends working out any wrinkles. Make sure your ends are sealed to surface. You can use a stencil brush to seal the ends. Clear up any excess glue with damp cloth. Let dry for 1/2 hour.

6) Thin down your Elmer's glue all to the consistency of cream.  Using a single stroke, apply two coats to surface with a soft brush, letting coats dry for 1 hour in between.  Let cure for 48 hours.

7) Apply two coats of water based semi-gloss varnish with a soft brush. I like Minwax semi-gloss water based varnish. Let dry.  Attach hardware.

Tips & Hints:

Don't apply varnish with a roller or sponge, it forms air bubbles.  Don't apply paint with a brush it can leave strokes.  Make sure your paints and sealers are dry, if it is cold to the touch it is not dry.  You can speed up the drying process by using a hair dryer on low heat about 6 inches from project.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Back Next
 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

                                                                                                                                                                            

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Home     Decoupage Papers      What's New      Supplies     How-To-Projects      Gallery      Contact Us   Links   
All images are the property of Southern Blackberry Designs, and are protected by U.S. copyright laws.
Unauthorized use of these images is strictly prohibited.